Micro view of NMR

From apimba
Jump to navigation Jump to search

Quantum transitions in nuclei

NMR from a micro-point of view is an instrumental technique that uses photons of radio frequency energy to cause a transition, or change in state, in an atom. Radio is used because the amount of energy needed to cause these transitions happens to fall in the radio region of the electromagnetic spectrum. The transitions are also quantized, which means there has to be the right amount of energy to cause a change of state, too much or too little and no change occurs.

There are many quantum transitions in atoms, but the ones manipulated in NMR are quantum spin transitions. Quantum spin has two states, often referred to as "up" and "down". In a natural environment these two states are equivalent in energy, so an atom could be in one or the other at any time with no change in energy. However, when the atom is placed in a strong magnetic field the states become non-equivalent, with one of the states a little higher in energy than the other. This difference in energy is the key to NMR. A photon with this amount of energy can then be shot at the atom, which will absorb it and cause a transition between the 'up' and 'down' spin states. Thus light can be used to probe substances at the atom level!

Note that the atom hasn't changed. It is still the same atom when it is placed in a magnetic field. Only the potential spin state energies have changed. Everything about atoms is discussed in probabilities, so the way to say it is that the spin state of the atom in a magnetic field is most likely the lower energy state.

At the atomic size scale, atoms are composed of protons and neutrons and electrons. All three of these have the same quantum spin and can be studied when placed in a strong magnetic field and pulsed with photons. Transitions are at different energies for the three types of subatomic particle so instruments are designed to look at them independently: Electron Spin Resonance (ESR or EPR) for electron spins and Nuclear Magnetic Resonance (NMR) for nuclear spins. For NMR, the hydrogen atom has just a single proton in its nucleus so the physics of spin transitions are easiest to study for this element. Other elements have many protons and neutrons so the net nuclear spin, called I, is considered when studying their spin transitions.

Net nuclear spin values ranging from I = 0 to I = 8 in ½-unit increments can be found across the entire periodic table. Protons and neutrons each have net spin of ½, but this derives from the elementary quarks and gluons of which they are composed. As a result of this complexity, no simple formula exists to predict I based on the number of protons and neutrons within an atom.

The formula for the number of states = 2I+1, thus a spin 1/2 nucleus such as a single hydrogen atom will have 2 states and 1 transition (when placed in a static magnetic field). For I greater than 1/2 there are more than two states and thus many transitions. Spin 1/2 nuclei are the best for NMR since two states with one transition gives good, clean spectra that are easily interpretable. A lot of information about the environment of a nucleus can thus be obtained, making 1H NMR the most useful analytical technique in science.

From here on, the focus will be on spin 1/2 nuclei, specifically 1H. This nucleus is referred to as "proton" in the NMR literature, but other spin 1/2 nuclei behave the same. Nuclei with spins other than 1/2 will have more than one transition and give much more complicated spectra, so these will be explored in another section.

Spectra

To obtain a spectrum, a spin 1/2 atom must first be placed into a static magnetic field to cause separation of the two states. The amount of separation depends on the gyromagnetic ratio (gamma) (g) for that element/elementary particle (a constant) and the intensity of the static magnetic field (B0) according to the derived equation:

v0=g*B0

The atom is then pulsed with a composite radio wave that includes the frequency v0, called the Larmor Frequency. The atom absorbs just the v0 part of the radio wave (since it is a quantum transition), and a detector in the same axis as the radio wave (usually the same antenna) is then turned on to receive any emitted energy.

Making this happen in an instrument is thus mainly an engineering problem.

From the equation above, since g is a constant for each element and B0 is a constant (it is a measure of the magnetic field strength in that instrument in the units of Tesla), there is just one frequency for that proton, which makes sense since there is just one transition, thus there is just one peak expected in the spectrum. In reality though, an atom never exists in isolation, so it never experiences the pure B0. The actual frequency v is thus slightly different for atoms of a particular g based on the actual magnetic field around the atom. These slight differences in frequency are what gives a spectrum of peaks for a molecule rather than a single peak. There is still just one transition for that atom type (if that type is spin 1/2, such as 1H), but the transition energy is different for each 1H that is in a different magnetic environment.

If the 1H is part of a molecule then 1H atoms in the molecule in similar magnetic environments can be grouped and can be expected to give one peak per group.

To see examples, the view will be increased beyond a single 1H atom and into a collection of 1H atoms as part of molecules, such as a solution of one compound in a solvent or a pure liquid, such as ethanol.

For a sample of ethanol (CH3CH2OH), we first have to list the spin 1/2 groups in the sample: 1H and 13C

  • Fortunately, the g for 1H and 13C are very different, which means that the radio frequencies needed to cause spin transitions are also different. If a narrow band of radio is used both to transmit and receive, it is possible to "see" 1H and 13C separately. In other words, when looking at 1H, the 13C will not be excited because the quantum energy is not correct. The 13C are invisible in 1H spectra, and the 1H are invisible in 13C spectra.

Next is a listing of 1H groups in the sample:

A group for the protons in the CH3 of ethanol

A group for the protons in the CH2 of ethanol

A group for the OH of ethanol.

Thus three peaks are expected in the 1H spectrum of this sample (the splitting of the peaks will be discussed later).

Proton NMR of ethanol.png

The units on the x axis are ppm, which is relative frequency, while the y axis is relative intensity.

  • Another spin 1/2 nucleus in this sample is carbon, specifically the 13C isotope. Based on the isotope abundance table, 13C is only 1.11% of the total carbon atoms in a sample. The other carbon atoms have spin 0 and are not visible in NMR, so, if the instrument is sensitive enough, it can detect the 1.1% of carbons in a sample that are spin 1/2.

A list of possible 13C carbons in the sample:

A group for the CH3 of ethanol

A group for the CH2 of ethanol.

There are no other carbon sources in this sample so there should be just 2 peaks in the spectrum (the lack of splitting will be discussed later).

13C NMR ethanol.png

Again, the units on the x axis are ppm, which is relative frequency, while the y axis is relative intensity. The ppm range is different than for the proton NMR spectrum because the g is different for the two nuclei, which makes the v0 different.

Radio pulse power

How powerful should the radio pulse be to get a good signal? Each transition requires one photon, so enough photons are needed in a pulse to cause transitions in all the nuclei in a sample. The total number of photons in a pulse of radio is the power of the pulse times the length of time that the pulse is turned on, where power is given in watts (W) and time in microseconds (µ). It is then a simple matter of running multiple experiments using different power and time settings until the maximum signal is achieved. The ideal numbers are actually limited by technical problems such as transmitter parameters and timing capabilities.

The pulse length at a specific power that gives the maximum signal is called the 90 degree pulse (for historic reasons).

Saturation

Since NMR looks at quantum transitions of nuclei, only at absolute zero will all the nuclei be in the lowest energy state. At other temperatures there is a population in both states, with a slight excess in the lower energy state at room temperature. The equation describing this is called the Boltzmann distribution, which holds at thermal equilibrium:

(number of nuclei in the higher state)/(number of nuclei in the lower state) = e-(difference in energies/a constant*absolute temperature)

Nh/Nl = e-DE/kT

An NMR signal is only obtained when there is emission of a photon, so only the slight excess in the lower state is 'available' for excitation and subsequent emission of a photon. Thus as more and more photons are included in the pulse, at some point the populations will equalize and there will be no more transitions and no more signal. Then, as more photons are added the populations will invert since the system is no longer at equilibrium, making the higher energy state slightly more populated. This will 'invert' the phase of the photons that are emitted after excitation. All these pulse lengths have names:

  • 90 degree pulse - first maximum signal
  • 180 degree pulse - first minimum signal
  • 270 degree pulse - second maximum signal but inverted phase
  • 360 degree pulse - second minimum signal

Peak Intensity

The next topic is an explanation for how big the peaks in the spectrum are. Since there is one photon absorbed per nuclear transition, if photons could be counted then it would give the number of excitable nuclei in the sample (subject to boltzmann distribution described in the saturation section). Photon counts are represented by areas of peaks in spectra. This makes NMR a potentially quantitative method. The complication is that it is assumed that all excited nuclei release their photons at the same time so that the detector can see them. For 1H NMR this is mostly true, but for other nuclei it is not true since other factors such as delay in photon emission depending on the environment causing it to no longer be quantitative.

Sensitivity

Since this technique involves photon absorption by individual nuclei, the more nuclei in the sample the stronger the signal. For 1H, all protons in a natural abundance sample are 1H and thus all are available for excitation.13C is only 1.1% of a natural abundance sample so this nucleus will be much less sensitive. The transition energy also influences the population difference in the Boltzmann equation which further alters the sensitivity of a particular nucleus. Sample size and other factors affect overall sensitivity. There are a number of equations that have been developed to attempt to quantify how these factors influence the sensitivity in an experiment.

Peak Splitting

In the 1H spectrum of ethanol above, two of the peaks are split into multiplets: a triplet and a quartet. The quartet is from the CH2, while the triplet is from the CH3. Remember that each group of magnetically equivalent 1H has one potential transition, so the apparent splitting of the peaks must be due to the environment around the nucleus, rather than the nucleus itself. Remember also that the location of the transition peak is due to the strength of the local magnetic field, which is different from the external magnetic field B0 because of electrons and other nuclei in the molecule. Combining these two concepts suggests that splitting of a nucleus is due to the presence of multiple populations of neighboring nuclei and electrons.

Fortunately, electrons in bonds are paired and have net spin 0, so they don't have multiple states when placed in a magnetic field. Carbons also have net spin 0 so they don't have multiple states either (13C does have two states but is present at only 1.1% of total carbon). Therefore the only source of multiple states in ethanol is other hydrogens. In a sample, the total 1H population is split into two for each 1H on the molecule due to the Boltzmann distribution as described previously. So the methyl protons in ethanol see four different environments due to the two populations of each 1H on the neighboring CH2. Four different magnetic environments thus leads to 4 different peaks for the methyl. Symmetry of the CH2 means that two of the four overlap, resulting in three peaks, with the central peak double in size.

Splitting.gif

Following the same logic, the CH2 in ethanol will have 6 peaks due to 6 different environments, two environments for each 1H in the methyl, with 4 of them overlapping due to symmetry of the methyl protons, resulting in a quartet.

In summary, 'splitting' of a peak in NMR is actually multiple peaks, with each peak in the multiplet representing one transition per environment. Overlap of the peaks due to symmetry is what gives an apparent multiplet. The distance between the peaks in a multiplet is called the coupling constant, J, and is displayed in Hertz.

Relaxation

A sample of menthyl anthranilate is placed into a strong magnetic field and pulsed with radio frequency photons in the 1H range. The excess population of protons that are in the lower energy state are excited into the higher energy state. The transmitter is turned off and the receiver is turned on. Then what?

Thermodynamics as embodied in the Boltzmann Distribution will drive the states back to equilibrium again, but it will not happen all at once. The process of states returning to equilibration is called relaxation. The image below is what the signal looks like once the receiver is turned on. There is an initial burst of photons, then a gradual decrease over time as the remaining protons return to the lower state:

Fid menthyl anthranilate.png

bottom axis is time in seconds

A good way to think of it is hitting a bell with a hammer. Even though the initial impulse of the hammer is over, the bell continues to ring at the same frequencies but with decreasing intensity over time.

The delay in states relaxing back to equilibration occurs due to several mechanisms:

  • Dipole-dipole interaction
  • Chemical shift anisotropy
  • Quadrupolar interaction (if I>=1)
  • Spin-rotation
  • Scalar
  • Paramagnetic

Relaxation Math - 2 states

Relaxation Math - transition probabilities

The equations for relaxation are complex and generally involve two numbers: the spin-lattice relaxation time T1 and the spin-spin relaxation time T2. Because both mechanisms are happening at the same time it is difficult to measure them independently, so a number of unique experiments have been designed to try to minimize the overlap in the times.

Related topics